Clarion S400 Manual de usuario descargar pdf (Pagina 17)

diagnostics

The microprocessor at the heart of your security system is constantly

monitoring all of the switches and sensors that are connected to it. It

detects any faulty switches and sensors and prevents them from dis-

abling the entire system. The microprocessor will also record and report

any triggers that occurred during your absence. Refer to the System

Status Chirps and Table of Zones charts for diagnostic information.

arming diagnostics

If the system is armed while an input is active (door open, sensor trig-

gering, etc.) the unit will chirp once when arming and then one more

time a few seconds later. This is called an open zone.

The security system will ignore the input that was active when the sys-

tem was armed, until the input goes away. Three seconds later the sys-

tem will monitor that input normally. For example, if your vehicle has

interior light exit delay, and you arm the system before the interior light

goes out, you may hear open zone notification chirps. Once the light

shuts off, however, the doors are monitored normally.

disarming diagnostics

If four chirps are heard when disarming, the system was triggered in

your absence. If five chirps are heard, a zone was triggered so many

times that false alarm prevention circuitry has bypassed that zone. The

status LED will indicate which zone was involved. (See Table of Zones

section of this guide.) The system will retain this information in its

nnoottee::

Open zone notification will not occur when using Silent

Arm/Disarm or if chirps have been programmed OFF.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Sin comentarios

Clarion S400 Manual de usuario Pagina 17