Clarion S400 Manual de usuario descargar pdf (Pagina 16)

interpret those triggers as false alarms. After the third trigger, the sys-

tem ignores, or bypasses, that sensor or switch (along with any other

sensors or switches sharing the same zone) for 60 minutes.

If the bypassed sensor tries to trigger the system while it is being

bypassed, the 60-minute bypass period will start over. This ensures that

a sensor that continually triggers will remain bypassed.

Doors are covered by the false alarm prevention circuitry differently; if

the alarm is triggered by an open door for three full cycles, the doors

will be bypassed until the trigger ceases.

The false alarm prevention circuitry is programmable. See Programming

Options section of this guide.

note: Arming and disarming the system does not reset this

function.The only ways to reset a bypassed zone are for it to

not trigger for 60 minutes, or to turn on the ignition. If testing

your system, it is important to remember that the false alarm

prevention circuitry programming can cause zones to be

bypassed and appear to stop working. If five chirps are

heard when disarming, the false alarm prevention circuitry

has been engaged. If you wish to clear the false alarm pre-

vention circuitry memory, turn the ignition key on.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Sin comentarios

Clarion S400 Manual de usuario Pagina 16