Clarion Ungo MS2004 Manual de instalación descargar pdf (Pagina 11)

MS2004 Installation Manual - Page 10

Entering System Programming

To enter System Programming:

1. Turn on ignition.

2. Within 5 seconds, press the valet switch 5 times.

• The siren will emit a buzzing sound, indicating that you have entered Programming.

3. Press the valet switch the number times equal to the System Parameter you want to change.

• The siren will chirp each time the valet switch is pressed.

4. Within 5 seconds, press the transmitter button corresponding to the desired operating mode for that System

Parameter.

• The siren will chirp to indicate the setting.

1 chirp = Button 1

2 chirps = Button 2

3 chirps = Button 3

5. When you are finished, turn the ignition key off to save the changes. You can turn the key off at any time during

programming and the changes that were made will be saved.

System Initialization and Default Reset

Following this procedure will set all System Programming Parameters to factory default settings.

1. Enter System Programming.

2. Press Transmitter Button 3.

• The siren will chirp 6 times indicating that the reset signal was received.

• All System Programming parameters are now set to factory default settings.

• The Arming Mode is set to Remote Arming only.

• The Valet Mode is off.

• The Disarm Code is 1.

3. Turn ignition off.

Programmable System Parameters

1. Ignition Controlled Door Locking. Selects whether or not the system automatically locks the doors when the ignition is

turned on. When selected, the Ignition Controlled Door Locking feature will automatically lock the doors 10 seconds after the

ignition key is turned on.

To prevent the keys from being locked inside the vehicle when Ignition Controlled Door Locking is on:

• The system will not lock the doors if any door is open when the ignition is turned on.

• The system will not lock the doors if any door is opened during the 10 second countdown.

2. Ignition Controlled Door Unlocking. Selects whether or not the system automatically unlocks the doors when the ignition

is turned off. When selected, the Ignition Controlled Door Unlocking feature will automatically unlock the doors when the

ignition key is turned off.

Programming

Feature Button 1 (default) Button 2 Button 3

Ignition Controlled Door Locking On Off

Ignition Controlled Door Unlocking On Off

Door Unlock Pulse Single Double

Door Lock Pulse Width 1 second 4 seconds

Passive Locking Off On

Door Entry Delay with Passive Arming Off On

Ignore Dome Light Delay Off Ignore

Auto Rearm Off On

Horn Honk / Arming Output Continuous Flashing

Trunk Disarm Feature Off On

Siren / Horn Chirps Siren only Horn chirps

Starter Defeat Output Normally Closed Normally Open

Auxiliary Function 2 Output Momentary Latched Timed Operation

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Comentarios a estos manuales

Sin comentarios

Clarion Ungo MS2004 Manual de instalación Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Clarion Ungo MS2004