Clarion M10 Series Manual de usuario descargar pdf (Pagina 14)

C-SPEC CORPORATION WIRELESS PRODUCTS

selecting the six least-significant digits automatically includes the other six.

Deleting the RF Address text unassigns the RF Address.

If no RF Address is entered, the unit will learn its RF Address upon each

power-up cycle.

Click Cancel or Done as appropriate to cancel the entry or to complete the

operation.

Removing an M10

When the Remove button is clicked, a message box will display “Are you sure

you want to remove .......”. Click OK to remove the unit, or Cancel to cancel

the operation. Clicking the OK button is final.

Configuring an M10

Clicking the Configure button brings up the M10 Configuration dialog box for

that unit. The parameters and values shown are those reflected in the

current data base for the currently selected unit.

The AUI Parameters, Code Channel, and Search Code are configured

directly from this dialog box, while the Retransmission Protocol and Channel-

Access Protocol may be configured by bringing up the appropriate dialog box

using the corresponding Set button.

The Default button sets all parameters back to the factory default

settings. When the Done button is clicked, the updated information is saved

in the M10 Manager data base, and any required configuration frames are

issued.

CONFIGURATION PARAMETERS

The configuration parameters are explained in this section. Each description

includes the permissible values that can be entered for the parameter

enclosed within braces, the default setting of the parameter, and a brief

explanation of the functionality of the parameter.

Spreading Code Selection

Code Channel {four hex digits} default = 2D1B. This is a four-hex-digit

pattern which specifies the sequence of spreading codes used for the data

portion of the frame transmission. This is a security measure. Any two M10s

must use the same Code Channel in order to exchange data. Enter by editing

as text.

Search Code {0,1,2,3,4,5,6,7} default = 0. There are eight Search Codes

available. These do not provide security, rather they can be selected to

provide isolation between independent M10s operating in close proximity.

Operation of different Search Codes simply avoids the transmissions of one

link from triggering detections on the other link. Select via a dropdown list.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

Sin comentarios

Clarion M10 Series Manual de usuario Pagina 14